I am very new to Modbus and PyModBus however I have spent a good amount of time trying to read up and experiment with it. If anyone could point me in the right direction I would appreciate it... I have a drive with distance, velocity, acceleration, and deceleration on registers 40001, 40003, 40005, and 40007 (respectively). I was initially able to write to the distance register, using client.write_register(0000, n). After trying to write to velocity the drive started going haywire and faulting, and spinning 10x as fast as it should've been. However, the real priority is reading registers. I am trying to read the data from these registers and having zero luck. I tried using request = client.read_holding_registers(0000,4) response = client.execute(request) print response However, all I get back is "ReadRegisterResponse (0)". So again, my big priority is trying to read values from these registers...any advice? (This is over TCP by the way) Continue reading...
